Steel Bellows

Stainless Steel Bellows are extensively utilised where either temperature, pressure or media prevent the use of Rubber Bellows. As with Stainless Steel Hose assemblies, Stainless Steel Bellows are produced from thin wall tube with the number of convolutions determining the available movement. With a Bellows unit, only a comparatively small number of convolutions can be safely engineered before the unit becomes unstable under pressure. For greater movement requirements, either additional bellows must be installed, or an alternative system design must be employed. As specific design criteria is generally the case with each expansion problem, each Bellows is produced to customers requirements, including length, pressure, end termination and movement requirements. The following sections give a brief outline of standard Stainless Steel Bellows:

 

Axial Bellows.

Axial Bellows are designed to absorb thermal expansion in straight pipe runs working below 10 bar. Each unit must be installed between two anchor points and have sufficient guides along the full pipe length.

 

Double-Tied Bellows.

Double-Tied Bellows are designed to absorb thermal expansion in a lateral plane and are usually positioned at 90 degrees to the main pipe run.  Larger movement capabilities are obtainable from this system in two lateral planes. Some axial movement is also catered for from these units.

 

Double-Hinged Bellows.

Double-Hinged Bellows are positioned in the same method as Double-Tied Bellows and can also absorb large movements. Unlike the Double-Tied Bellows, lateral movement can be accommodated in one plane only due to the hinge brackets. These systems are ideal for high-pressure systems, or where forces on anchor points could not be contained.

 

Single-Hinged Bellows.

Single-Hinged Bellows are used in either a two or three-pin systems where very large amounts of expansion need to be taken up. Again, these units are ideal for high-pressure applications and work in a similar way to the Double-Hinged Bellows

 

End Fittings.

Each Bellows is available with a range end terminations including Fixed and Swivel Flanges, Stub Pipes, BSP Male and Female Thread and Copper S

 

Phone +44(0)1606 836024
Email sales@flexibleconnections.co.uk
Fax +44(0)1606 836241